Furuno RC-1500-1T Operator's Manual page 21

2. Unfasten screws A and push back B (for both right and left) shown below to remove the
printer cover.
Screw
3. Swing out the paper cover by 100 to 120 then lift it up from the right-hand side to remove
it from the printer.
4. Referring to the previous figure, lift the paper bail C. As shown in the figure which follows,
remove the roll paper stay D and then take out the roll paper.
Loading new roll paper
5. Insert the roll bar into the roll paper from the left side. Set the roll paper to the roll paper
cradle.
Roll Bar
C
A
B
D
Roll Paper
Type: A2 1PLT W
Code No.: 000-134-903
Type: T-214 white OKFIP
Code No.: 000-119-433
Roll Paper
Cradle
Paper
Paper
Cover
Select
either.
(no carbon)
2 – 7