Furuno RC-1500-1T Operator's Manual page 286

2-4
15. Press [Enter] to open the selection window.
Setup
System Date & Time
Preferred NCS
MES Operation Mode
Nav Port
Active Port
Message Output Port
EGC Output Port
9. Configuration
Figure 2-9 System setup menu, nav port
16. Select the navigation device which is interfaced to the
FELCOM 12.
No connection
OFF:
EXT: Select this setting when external navigation device is
connected. The FELCOM 12 automatically selects ship's
position information in the order of GPS, LC, and
DECCA.
INT: Internal GPS board provides position data.
The Nav Port setting in the FFA version cannot be set to
Note:
other "INT."
Note: If there is no navigation equipment connection (Nav Port
setting is "OFF"), you should input dead reckoning posi-
tion in the Position menu. Refer to page 2-26.
17. Press [Enter] to close the selection window.
18. Press [ ] to advance the cursor to the Active Port line.
19. Press [Enter] to open the selection window.
Setup
System Setup
System Date & Time
Preferred NCS
MES Operation Mode
Nav Port
Active Port
Message Output Port
EGC Output Port
9. Configuration
Figure 2-10 System setup menu, active port
20. Select active port (DTE); "DTE1" or "ALL".
DTE1: Only DTE1 is active.
ALL:
DTE1, DTE2 and PC/DATA are active.
21. Press [Enter] to close the selection window.
22. Press [ ] to send the cursor to the Message Output Port line.
System Setup
01:53 97-08-04 (YY-MM-DD)
IOR
INMARSAT-C
DTE1OFF
OFF
DTE1
EXT
DTE1
INT
01:53 97-08-04 (YY-MM-DD)
IOR
INMARSAT-C
OFF
DTE1
DTE1
ALL
DTE1