Furuno RC-1500-1T Operator's Manual page 285

7. Press [Enter] to open the selection window.
Setup
System Date & Time
Preferred NCS
MES Operation Mode
Nav Port
Active Port
Message Output Port
EGC Output Port
9. Configuration
Figure 2-7 System setup menu, preferred NCS
8. Select appropriate NCS (Auto, AOR-West, AOR-East, POR or
IOR) by arrow keys. The FELCOM 12 will search for that NCS
signal each time it is turned on. The Auto setting searches all NCS
signals to find the most suitable NCS; thus, scanning can take
quite some time. (For reference, the coverage range of each satel-
lite is shown in the figure on page 8.)
If you want to change the NCS channel temporarily, refer to "Se-
lecting NCS channel" on page 7-4.
9. Press [Enter] to close the selection window.
10. Press [ ] to advance the cursor to the MES Operation Mode line.
11. Press [Enter] to open the selection window.
Setup
System Date & Time
Preferred NCS
MES Operation Mode
Nav Port
Active Port
Message Output Port
EGC Output Port
9. Configuration
Figure 2-8 System setup menu, MES operation mode
12. Select operating mode, either Inmarsat C or EGC. The Inmarsat
C setting provides telex communications and operates as an EGC
receiver when not transmitting or receiving. The EGC setting en-
ables EGC-only receiver operation. In this case EGC RECEIVER
appears in reverse indication at the bottom of the screen.
13. Press [Enter] to close the selection window.
14. Press [ ] to advance the cursor to the Nav Port line.
Note: The MES Operation Mode in the FFA version cannot
be set to other than"Inmarsat C."
System Setup
01:53 97-08-04 (YY-MM-DD)
Auto
IOR
INMARSAT-C AOR (WEST)
OFF AOR (EAST)
POR
DTE1
IOR
DTE1
System Setup
01:53 97-08-04 (YY-MM-DD)
IOR
INMARSAT-C
INMARSAT-C
OFF
EGC
DTE1
DTE1
2-3