Installing The Accessories; Accessories Package Contents - Cisco IDS 4210 - Intrusion Detection Sys 4210 Sensor Installation Manual

Chapter 2 Installing IDS-4210
For More Information
•
•

Installing the Accessories

You can install a bezel, and center or front mounting brackets for the IDS-4210.
This section contains the following topics:
•
•
•
•

Accessories Package Contents

The following items are shipped in the accessories package for IDS-4210:
•
•
•
•
•
•
•
Installing and Removing the Bezel
You can install a Cisco bezel for IDS-4210.
To install and remove the bezel on IDS-4210, follow these steps:
OL-8677-01
For the procedure for using HTTPS to log in to IDM, refer to
For the procedures for configuring intrusion prevention on your sensor, refer to the following
documents:
– Installing and Using Cisco Intrusion Prevention System Device Manager 5.1
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
–
5.1
Accessories Package Contents, page 2-7
Installing and Removing the Bezel, page 2-7
Installing Center Mount Brackets, page 2-8
Installing Front Mount Brackets, page 2-10
Cisco IDS-4210 bezel
Power cable
Network patch cable
Computer interconnection cable
Dual serial communication cable
Rack mounting brackets
Documentation and software
Cisco IDS recovery/upgrade CD
–
Cisco Documentation CD
–
Documentation Roadmap for Cisco Intrusion Prevention System 5.1
–
Regulatory Compliance and Safety Information for the Cisco Intrusion Prevention System 4200
–
Series Appliance Sensor
Installing Cisco Intrusion Prevention System Appliances and Modules 5.1
Installing the Accessories
Logging In to IDM.
2-7