Front Panel - NEC ES1200 User Manual

Front Panel

7. Replace the 3.5-inch drive bay. Insert the tabs into
their slots on the chassis. Slide the drive bay towards
the bottom of the chassis until the tabs hit their
stops.
8. Connect the signal and power cables to the drives as
shown in Figure 5-11.
Note: Verify that all cables are seated and routed
properly.
9. Replace the screw on the drive bay. Replace the left
side panel and power on the system.
10. Remove the drive serial number from the equipment
log.
The plastic front panel assembly is a one piece
assembly. The appropriate removable filler panels are
attached to the corresponding EMI shields. If you are
installing peripheral devices in the external bays above
the 3.5-inch floppy disk drive, you must remove the
front cover along with the corresponding filler panel
and EMI shield.
Upgrades and Options
5-25