NEC ES1200 User Manual page 83

Figure 5-4. Replacing the Pentium II Processor
1. Power off the system and remove the left side panel
as described earlier in this chapter.
Notice: Observe static precautions. Use an antistatic
wrist strap. Hold the processor only by its edges.
2. Remove the processor module from its socket by
pressing the release latches on either side of the
module and pulling the module out of the mounting
bracket.
3. The heat sink is attached to the processor with two
heat sink clips. Remove the heat sink by removing
the heat sink clips. Make sure the heat sink has a
heat transfer pad on the bottom.
4. Remove the replacement processor from its protective
wrapper, holding the processor by the edges.
5. Position the heat sink on the replacement processor
module and insert the heat sink clips that secure the
heat sink to the processor.
A
Upgrades and Options
5-9