NEC ES1200 User Manual page 104

5-30
Upgrades and Options


Your system comes with a three-connector IDE
interface cable attached to the system board
secondary IDE connector. This cable should be used
to add your removable media devices.


If only one device is on a channel connector it must
be set as the master device.


If a HDD and another device is on a channel
connector, the HDD should be the master device.
If you are adding or removing a SCSI removable media
device, consider the following:
The system uses single-ended SCSI host adapter and
devices. Failure to install single-ended SCSI drive
types can result in electrical damage to the host
adapter and the peripherals.
The tape drive SCSI address assignment is 2.
The SCSI termination resistors must be installed in
the last SCSI drive of the daisy chain cabling. If you
are using SCSI hard drives, the "Terminator Enable"
jumper must be installed in the last hard disk drive
of the daisy chain cabling (top drive bay 1, SCSI ID
= 0). The SCSI terminators must be removed from
all other drives. If the SCSI tape is your only SCSI
device on the on-board SCSI controller, termination
must be installed in the tape drive.
If you are installing a SCSI tape drive in bays B or
C, you must use a SCSI wide to narrow adapter.
If the SCSI tape drive you are installing will be your
only SCSI device on the on-board SCSI controller,
use the two-connector SCSI cable that was shipped
with the device. If you are presently using SCSI
hard drives and you are installing a SCSI tape drive
in bays B or C, you must use the optional six-
connector SCSI cable.