Removable Media Devices - NEC ES1200 User Manual

Removable Media Devices

A variety of IDE and SCSI removable media devices can
be installed in peripheral bays A, B, and C. An IDE CD-
ROM is always mounted in bay A. A 3.5-inch diskette
drive is always mounted in bay D. Other devices should
be installed in the first available bay from the top (bay
A). Contact your sales representative or dealer for a list
of approved devices.
BAY A
BAY B
BAY C
BAY D
If you are adding or removing an IDE removable media
device, consider the following:
The system board supports a primary and secondary
IDE channel connector. Each of these supports two
devices, for a total of four IDE devices.
A first (master) device and a second (slave) device
are supported on both the primary and secondary
IDE connector. The device configuration, master
versus slave, is determined by jumpers on the
device. Cable Sense (CS) device configuration is not
supported.
Your system comes with a three-connector IDE cable
connecting the first hard disk drive (HD0) and the
CD-ROM to the system board primary connector.
The first disk drive is set as the master device and
the CD-ROM that comes with your system is set as
the slave device on this connector.
Upgrades and Options
5-29