Removing A Side Panel - NEC ES1200 User Manual

Removing a Side Panel

!
To install options in your system, you must remove the
side panel on the left side of the system (as viewed from
the front). The side panel on the right side of the
system (as viewed from the front) only has to be
removed when adding removable media devices.
Notice: For proper cooling and airflow, do not operate
the system with the side panels removed. Always
replace the panels before powering on the system.
Caution: If you are removing the side panel after the
system is set up, you must first power off the system
and all external devices. Unplug the system power cord
To remove a side panel:
1. Power off the system and ensure it is disconnected
from the ac wall outlet.
2. The side panel is secured to the chassis with two
screws. Remove the screws (Figure 5-1) securing the
side panel. Save the screws for reattaching the side
panel.
3. Slide the side panel toward the rear of the chassis.
This unlocks the locking fingers behind the side
panel.
4. Pull the side panel up and away from the chassis.
Upgrades and Options
5-3