NEC ES1200 User Manual page 97

Figure 5-10. Removing the Disk Drive Bay
9. Replace the 3.5-inch drive bay. Insert the tabs into
their slots on the chassis. Slide the drive bay towards
the bottom of the chassis until the tabs hit their
stops.
10. Connect the signal and power cables to the drives as
shown in Figure 5-11. All device power cables are
labeled and must be installed in specific locations as
shown below:
DRIVE LOCATION
1 (HD0)
2 (HD1)
3 (HD2)
11. Swing the drive bay into the chassis and replace the
two screws on the drive bay.
12. Replace the left side panel and power on the system.
Configure the system as described in the Configuring
Your System chapter.
POWER CONNECTOR
P7
P8
P9
Upgrades and Options
5-23