Installing A 5.25-Inch Device - NEC ES1200 User Manual

Installing a 5.25-Inch Device

!
Caution: CD-ROM devices contain a laser system and
are classified as CLASS 1 LASER PRODUCTS. To use
these devices, thoroughly read the documentation
provided by the CD-ROM manufacturer, and keep the
documentation for future reference. In case of any
trouble with a CD-ROM, please contact your nearest
service representative. To prevent direct exposure to
the laser beam, do not try to open the enclosure.
Use of controls or adjustments or performance of
procedures other than those specified in the CD-ROM
manufacturer's documentation may result in hazardous
radiation exposure
1. Power off the system and remove the side panels as
described earlier in this chapter.
2. Remove the front panel, EMI shield, and filler panel
covering the bay into which you are installing a
peripheral device as described earlier in this chapter.
Notice: Observe static precautions. Use an antistatic
wrist strap.
3. Remove the device from its protective wrapper and
place it on an antistatic surface. Record the drive
model and serial number in the equipment log.
4. Set any drive jumpers or switches before you install
the drive. See the documentation that comes with the
device for jumper or switch information.
Notice: If the drive comes with drive rails, do not use
them. Remove any rails already attached.
5. Slide the drive into the bay until the screw holes line
up. It may be necessary to temporarily loosen the
mounting screws on the already installed drives to
position the new drive. Secure the drive to the bay
with the four supplied screws. See Figure 5-15.
Upgrades and Options
5-31