Hard Disk Drives - NEC ES1200 User Manual

5-20

Hard Disk Drives

Upgrades and Options
The system supports a variety of IDE and SCSI hard
disks. Contact your sales representative or dealer for a
list of approved devices. The internal hard disk drives
are located in the 3.5-inch drive bay (Figure 5-9, A).
If you are adding or removing an IDE hard disk device,
consider the following:
The system board supports a primary and secondary
IDE channel connector. Each of these supports two
devices, for a total of four IDE devices.
A first (master) device and a second (slave) device
are supported on both the primary and secondary
IDE connector. The device configuration, master
versus slave, is determined by jumpers on the
device. Cable Sense (CS) device configuration is not
supported.
Figure 5-9. 3.5-Inch Drive Bay Locations
A