Scsiselect Configuration Settings - NEC ES1200 User Manual

4-24

SCSISelect Configuration Settings

OPTION
SCSI Bus Interface Definitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Additional Options
Boot Device Options
Boot SCSI ID
Boot LUN Number
SCSI Device Configuration
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable Disconnection
Initiate Wide Negotiation
Send Start Unit Command
BIOS Multiple LUN Support
Include in BIOS Scan
1
No effect if BIOS is disabled.
2
Do not remove media from a removable media drive if it is under BIOS control.
4
Set to 40.0 if the SCSI bus has only ultra/wide hard disk drives or 10.0 if Tape is used.
5
Set to Yes for hard disk drives or No if Tape is used.
Configuring Your System
The following keys are active for all SCSISelect screens:
KEY
Arrows Up and down arrows move from one parameter to
another within a screen.
ENTER Displays options for a configurable parameter.
Selects an option.
ESC Moves back to previous screen or parameter or
EXIT if at the Main menu.
F5 Switches between color and monochrome.
F6 Resets to host adapter defaults.
Table 4-7 shows the normal settings for the SCSISelect
Utility and provides a place for you to record any
changes you make to these settings.
Table 4-7. SCSISelect Setup Configurations
RECOMMENDED SETTING
7
Enabled
Low ON/High ON
Press ENTER for menu
0
0
Press ENTER for menu
Yes
40.0
Yes
Yes
Yes
no
Yes
ACTION
OR DISPLAY ONLY
4
5
1 and
5
1
YOUR
CONFIGURATION