NEC ES1200 User Manual page 95

Your system comes with a three-connector IDE cable
connecting the first hard disk drive (HD0) and the
CD-ROM to the system board primary connector.
The first disk drive is set as the master device and
the CD-ROM that comes with your system is set as
the slave device on this connector.


Your system comes with a three-connector IDE
interface cable attached to the system board
secondary IDE connector. When adding IDE devices,
such as hard disk, to this cable valid configurations
are:
Connector
Secondary
If you are adding or removing a SCSI hard disk device,
consider the following:
The system uses single-ended SCSI host adapter and
devices. Failure to install single-ended SCSI drive
types can result in electrical damage to the host
adapter and the peripherals.
The hard disk SCSI address assignment is:
SCSI ID ASSIGNMENT
BAY DEVICE
1 First Hard Disk
2 Second Hard Disk
3 Third Hard Disk
If you are installing a SCSI hard drive, you must use
the optional six-connector SCSI cable.
The "Terminator Enable" jumper must be installed
in the last hard disk drive of the daisy chain cabling
(top drive bay 1, SCSI ID = 0). The SCSI terminators
must be removed from all other drives.
Device
HD1 (master)
Empty or HD2 or Tape (slave)
ADDRESS
0
1
3
Upgrades and Options
5-21