Floppy Disk Drive Activity Led Does Not Light; Hard Disk Drive Activity Led Does Not Light - NEC ES1200 User Manual

Floppy Disk Drive Activity LED Does Not Light

Hard Disk Drive Activity LED Does Not Light

Check the following:
Are the floppy disk drive power and signal cables
properly installed?
Is the floppy disk drive properly configured in
Setup?
If you are using the onboard floppy disk controller, use
Setup or the RCU to make sure that Onboard Floppy is
set to Enabled. Conversely, to use an optional
fixed/floppy disk controller, make sure that Onboard
Floppy is set to Disabled. For information about
running Setup or the RCU, refer to the Configuring
Your System chapter.
If the problem persists, there may be a problem with
the floppy disk drive, system board, or drive signal
cable. Contact your service representative for
assistance.
If you have installed one or more hard disk drives in
your system, check the following:
Is the disk drive seated properly?
Are the jumpers on the system board set correctly?
Is the hard disk controller properly configured in
the RCU?
If you received error messages, refer to the Error
Messages section for information about error messages.
If you did not receive error messages, run the RCU to
make sure that the hard disk drive is configured with
the correct parameters. For information about running
the RCU, refer to the Configuring Your System chapter.
If the problem persists, there may be a problem with
the hard disk drive, the optional controller board,
system board, drive signal cable, or LED connector.
Contact your service representative for assistance.
6-13
Problem Solving