Configuring Cluster Parameters - 3Com 5500-SI Configuration Manual

606 C 32: C
HAPTER LUSTERING
Configuring Cluster
Parameters
Table 659 Configure NTDP parameters (continued)
Operation
Configure the time that
collected devices wait
before forwarding the
topology-collection
request
Configure the time that a
port waits before it
forwards the topology
request packet to the next
port
Configure the interval of
periodic topology
information collection
Exit system view.
Start topology information
collection
Enabling the Cluster Function
Table 660 Enable the cluster function on a switch
Operation
Enter system view
Enable the cluster function
on a switch
Configuring cluster parameters manually
Table 661 Configure cluster parameters manually
Operation Command
Enter system view system-view
Specify the management-vlan vlan-id
management VLAN
Enter cluster view cluster
Configure an IP ip-pool administrator-ip-address
address range for { ip-mask | ip-mask-length }
cluster members
Configure a cluster build name
with the current
switch as the
management device
Configure a multicast cluster-mac H-H-H
MAC address for the
cluster
Set the interval for the cluster-mac syn-interval
management device time-interval
to send multicast
packets
Configure the valid holdtime seconds
holdtime for a switch
Set the interval of timer interval
handshake packets
Command
ntdp timer hop-delay time Optional
ntdp timer port-delay time Optional
ntdp timer
interval-in-minutes
quit
ntdp explore
Command
system-view
cluster enable
Remark
Argument time is the delay time.
Argument time is the delay time.
Optional
Argument interval-in-minutes is the
needed time.
—
Optional
Remark
—
Required
Remark
—
This is to specify the management
VLAN on the switch
—
Optional
Optional
Argument name is the cluster name.
Optional
This is to set a multicast MAC address
for the cluster.
Optional
Argument time-interval is the
multicast packet interval.
Optional
Argument seconds is the valid
holdtime, which is 60 seconds by
default.
Optional
Argument interval is the handshake
packet interval, which is 10 seconds
by default.