Sending The Information To Control Terminal - 3Com 5500-SI Configuration Manual

476 C 22: F S
HAPTER ILE YSTEM
Sending the Information
to Control Terminal
M
ANAGEMENT
4 Configuring loghost
The configuration on the loghost must be the same with that on the Switch. For
related configuration, see the configuration examples in the latter part of this chapter.
Setting Format of Time Stamps Due to be Sent to Log Host
Table 532 describes the detailed configuration tasks on the switch.
Table 532 Configure the information to be sent to log host
Operation
Enter system view
Enable information
center
Output information to
log host
Specify the interface
that sends log
information to log host
Define source of
information
Set the format of time
stamps to be sent to log
host
If users require debugging messages for some modules of the switch, they need to
specify the type of information as debug while setting information source, and to
enable debugging for the corresponding modules using the debugging command.
To send information to the control terminal, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 533 Enable/disable info-center
Operation
Enable info-center
Disable info-center
Info-center is enabled by default. After info-center is enabled, system performances
are affected when the system processes much information because of information
classification and outputting.
2 Configuring to output information to the control terminal.
Perform the following operation in Table 534.
Command
system-view
info-center enable
info-center loghost host-ip-addr [
channel { channel-number | channel-name
} | facility local-number | language {
chinese | english } ]
info-center loghost source interface-type
interface-number
info-center source { modu-name |
default } channel { channel-number |
channel-name } [ { log | trap | debug } * {
level severity | state state } * ]
info-center timestamp loghost { date |
no-year-date | none }
Command
info-center enable
undo info-center enable
Description
-
Optional;
Enabled by default.
Required;
By default, the switch
does not send information
to log host.
Enter the proper IP
address. The system will
take loopback addresses
as invalid and indicate as
such.
Optional
Required
Optional