Configuration Procedures In The Source Switch; Configuration Procedures In The Intermediate Switch - 3Com 5500-SI Configuration Manual

Configuration
Procedures in the Source
Switch
Configuration
Procedures in the
Intermediate Switch
Table 404 Configuration procedures in the source switch
Operation
Enter system view
Establish Remote-probe
VLAN, and enter VLAN view
Define the current VLAN as
Remote-probe VLAN
Exit the current view
Enter the Ethernet port view
of Trunk ports
Configure Trunk ports so that
packets of the Remote-probe
VLAN can pass through
Exit the current view
Configure the source group
of remote mirroring
Configure the source ports of
remote mirroring
Configure the reflector ports
of remote mirroring
Configure the remote-probe
VLAN for the source group of
remote mirroring
Display the configuration for
the source group of remote
mirroring
Table 405 Configuration procedures in the intermediate switch
Operation
Enter system view
Establish remote-probe VLAN,
and enter VLAN view
Exit the current view
Enter the Ethernet port view of
Trunk ports
Configure Trunk ports so that
packets in the remote-probe
VLAN can pass through
Command
system-view
vlan vlan-id
remote-probe vlan enable
quit
interface interface-type
interface-number
port trunk permit vlan
remote-probe-vlan-id
quit
mirroring-group group-id
remote-source
mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }
mirroring-group group-id
reflector-port reflector-port
mirroring-group group-id
remote-probe vlan
remote-probe-vlan-id
display mirroring-group
remote-source
Command
system-view
vlan vlan-id
quit
interface interface-type
interface-number
port trunk permit vlan
remote-probe-vlan-id
RSPAN Features 383
Description
—
The parameter vlan-id represents
the ID of the Remote-probe VLAN.
Required.
—
—
Required.
—
Required.
Required.
Required.
The reflector ports of remote
mirroring cannot enable STP, and
have to be Access ports.
The reflector ports cannot have
the vlan-vpn commands
configured.
Required.
Optional.
The display command can be
used under any view.
Description
—
The parameter vlan-id
represents the ID of the
remote-probe VLAN.
—
—
Required.
This configuration is necessary
for ports of intermediate
switch that are connected with
the source switch or the
destination switch.