Displaying And Debugging 802.1X; Auto Qos; Configuration Example - 3Com 5500-SI Configuration Manual

Displaying and
Debugging 802.1x

Auto QoS

802.1x Configuration
Example
CAMS is configured to disable use of multiple network adapters, proxies, or IE
■
proxies.
By default, an 802.1x client allows the use of multiple network adapters, proxies, and
IE proxies. If CAMS is configured to disable the use of multiple network adapters,
proxies, or IE proxies, it prompts the 802.1x client to disable use of multiple network
adapters, proxies, or IE proxies through messages after the supplicant system passes
the authentication.
This function needs the support of 3Com's 802.1x client.
As for the proxy detecting function, you need to enable this function on both the 802.1x
client and CAMS. You need also to enable client version detecting on the switch (refer
to the dot1x version-check command for more).
After the above configuration, execute
running of the VLAN configuration, and to verify the effect of the configuration.
Execute command in User View to reset 802.1x statistics. Execute
reset
command in User View to debug 802.1x.
Table 428 Displaying and Debugging 802.1x
Operation
Display the configuration, running
and statistics information of 802.1x
Reset the 802.1x statistics
information
Enable the error/event/packet/all
debugging of 802.1x
Disable the error/event/packet/all
debugging of 802.1x.
Auto QoS uses the Filter-ID standard RADIUS attribute.
Table 429 Auto QoS
Auto QoS
Filter-id
Networking Requirements
As shown in the Figure 106, the workstation of a user is connected to the port
Ethernet 1/0/1 of the Switch.
The switch administrator will enable 802.1x on all the ports to authenticate the users
so as to control their access to the Internet. The access control mode is configured as
based on the MAC address
All the users belong to the default domain
users. RADIUS authentication is performed first. If there is no response from the
RADIUS server, local authentication will be performed. For accounting, if the RADIUS
server fails to account, the user will be disconnected. In addition, when the user is
accessed, the domain name does not follow the user name. Normally, if the user's
traffic is less than 2 kbps consistently over 20 minutes, they will be disconnected.
802.1x Client Version Checking Configuration 403
command in any view to display the
display
Command
display dot1x [ sessions | statistics ] [
interface interface_list ]
reset dot1x statistics [ interface
interface_list ]
debugging dot1x { error | event | packet |
all }
undo debugging dot1x { error | event |
packet | all }
Return String
student
3com163.net
debugging
Comment
QoS profile name
, which can contain up to 30