Sending The Information To Snmp Network Management - 3Com 5500-SI Configuration Manual

482 C 22: F S
HAPTER ILE YSTEM
Sending the Information
to SNMP Network
Management
M
ANAGEMENT
specifies the module name;
modu-name
refers to the severity levels;
information with the level below it will not be output.
channel number and
When defining the information sent to the trap buffer,
must be set to the channel that corresponds to the Console direction.
channel-name
Every channel has been set with a default record, whose module name is
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there is
no specific configuration record for a module in the channel, use the default one.
If you want to view the debugging information of some modules on the Switch, you
must select
debugging
meantime using the
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View.
Table 550 Configuring the Output Format of Time-stamp
Operation
Configure the output format of
the time-stamp
Output time-stamp is disabled
To send information to SNMP NM, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 551 Enabling/Disabling Info-center
Operation
Enable info-center
Disable info-center
Info-center is enabled by default. After info-center is enabled, system performances
are affected when the system processes much information because of information
classification and outputting.
2 Configuring to output information to SNMP NM
Perform the following operation in System View.
Table 552 Configuring to Output Information to SNMP NM
Operation
Output information to SNMP NM
Cancel the configuration of outputting
information to SNMP NM
default
specifies the severity level of information. The
severity
specifies the channel name.
channel-name
as the information type when configuring information source,
command to turn on the debugging Switch of those
debugging
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
Command
info-center enable
undo info-center enable
Command
info-center snmp channel {
channel-number | channel-name }
undo info-center snmp channel
represents all the modules;
channel-number
channel-number
level
specifies the
or
default