3Com 5500-SI Configuration Manual page 477

Table 534 Configuring to Output Information to Control Terminal
Operation
Output information to Console
Cancel the configuration of
outputting information to Console
3 Configuring the information source on the Switch.
With this configuration, you can define the information sent to the control terminal
that is generated by which modules, information type, information level, and so on.
Perform the following operation in System View:
Table 535 Defining Information Source
Operation
Define information source
Cancel the configuration of
information source
specifies the module name;
modu-name
refers to the severity levels;
information with the level below it will not be output.
channel number and
When defining the information sent to the control terminal,
must be set to the channel that corresponds to the Console direction.
channel-name
Every channel has been set with a default record, whose module name is
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there is
no specific configuration record for a module in the channel, use the default one.
If you want to view the debugging information of some modules on the Switch, you
must select
debugging
meantime using the
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View:
Table 536 Configuring the Output Format of Time-stamp
Operation
Configure the output format of
the time-stamp
Output time-stamp is disabled
4 Enable terminal display function
To view the output information at the control terminal, you must first enable the
corresponding log, debugging and trap information functions at the Switch.
For example, if you have set the log information as the information sent to the control
terminal, now you need to use the
terminal display function of log information on the Switch, then you can view the
information at the control terminal.
Command
info-center console channel{ channel-number
| channel-name }
undo info-center console channel
Command
info-center source { modu-name | default }
channel { channel-number | channel-name } [ {
log | trap | debug }* { level severity | state
state }* ]
undo info-center source { modu-name | default }
channel { channel-number | channel-name }
default
specifies the severity level of information. The
severity
specifies the channel name.
channel-name
as the information type when configuring information source,
command to turn on the debugging Switch of those
debugging
Command
info-center timestamp { log | trap | debugging
} { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
terminal logging
Logging Function 477
represents all the modules;
channel-number
channel-number
command to enable the
level
specifies the
or
default