Arming The Starter Kill; Remote-Starting Your Vehicle; Remote-Starting; Driving Off - Autostart AS-2310TW-FM User Manual

Arming the Starter Kill

The starter kill (if installed) can be configured by the installer so as to arm automatically (passive
mode) or not to arm automatically (active mode).
• To disarm the starter kill, press the
The parking lights will flash twice.
If remote door locks are installed, this will also unlock the doors.
• To arm the Starter Kill, press the
The parking lights will flash once.
If remote door locks are installed, this will also lock the doors.
• In passive mode, the starter kill will automatically arm if the ignition key is not inserted
Into the ignition switch within 1 or 3 minutes after unlocking (the key sense feature
must be installed).

Remote-Starting Your Vehicle

Remote-starting

Press the button for approx. 1 second. The parking lights will come
START/STOP
that the remote starter has received your signal. Approximately 5 seconds later, the engine will
start. The parking lights will remain
If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.

Driving Off

With the vehicle running under remote control, press the
doors. Enter the vehicle and do the following:
Turn the ignition key to the
IGNITION ON (RUN)
while the engine is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.

Remote Starter Features

Idle Mode

Convenience feature: Idle mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no key in the
ignition switch) while the engine is running. For example, if you stop for a delivery or at a conveni-
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
To leave the vehicle in idle mode:
1. With the engine running, press the
button on the remote control until the parking lights come on.
START/STOP
2. Remove the key and exit the vehicle. The engine will go on running.
3. Lock the doors if needed.
The engine will go on running until the user re-enters the vehicle or until the expiration of the
engine run time.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
User Guide
button on the transmitter.
UNLOCK
button on the transmitter.
LOCK
during the pre-programmed run time of the engine.
ON
button to disarm and unlock the
UNLOCK
position. (Do not turn the key to the
or button (to unlock the doors) or the
LOCK UNLOCK
to inform you
ON
position
CRANK
P. 5