Starter Kill Arming Mode; Lock Pulse Duration; Flashing Led - Autostart AS-2272 Installation Manual

Starter Kill Arming Mode

Note: It can only be activated if button Ι is programmed as
The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm
automatically) or Active Mode (so as to require the user's intervention for arming). By default, the
Remote Car Starter is configured to Passive Mode.
Passive mode:
• To arm the Starter Kill, press the
• In Passive Mode, the Starter Kill will also automatically arm 1 minute (by default) or 3 minutes
(if configured this way) after the ignition is turned
doors are monitored).
- The LED on the antenna will flash quickly during the countdown preceding the
activation of the Starter Kill.
- Once the activation countdown expires, the LED will send a series of quick double
flashes to indicate that the Starter Kill is now armed.
• To disarm the Starter Kill, press the
- The Starter Kill will automatically rearm itself after 1 minute (by default) or 3 minutes
(if configured this way) if no door is left opened (if the doors are monitored) and the
ignition is not turned
Active Mode:
• To arm the Starter Kill, press the
- The parking lights will flash once.
- The LED on the antenna will flash slowly.
- If remote door locks are installed, this will also lock the doors.
• To disarm the Starter Kill, press the
- The parking lights will flash twice.
- The LED on the antenna will remain
- If remote door locks are installed, this will also unlock the doors.

Lock Pulse Duration

•
Option 1:
•
Option 2:
•
Option 3:

Flashing LED

To gain access to this feature, make sure the Flashing LED option has been enabled at the time of
programming.
Flashing LED ON: The LED will flash at all times (being passive or active arming) to denote
•
that the Starter Kill is active.
Active arming: the LED flashes normally.
Passive arming: the LED will flash at a faster rate during the countdown until the Unit
In Valet Mode: the LED will be on solid.
Flashing LED OFF: The LED will not flash when the module is armed (passive or active
•
Installation Guide
button on the transmitter, OR
Ι
button on the transmitter.
Ι
.
ON
button on the transmitter.
Ι
button on the transmitter.
Ι
7/10-sec. and 7/10-sec.
LOCK
4-sec.
LOCK/UNLOCK
A single 7/10-sec.
Used for double-pulse Disarm/Unlock systems
is armed, at which time the flashing rate will slow down.
arming). However, if the module is in Valet Mode, the LED will remain
on solid when the Ignition is
LOCK
or once the last door is closed (if the
OFF
.
OUT
UNLOCK
pulses.
pulse and two ¼-sec.
LOCK
.
OFF
or button.
UNLOCK
pulses by default.
pulses.
UNLOCK
P. 21