Supplementary Information; Fifth Relay Output (2Nd Ignition Or 2Nd Accessories Or 2Nd Crank Output); Ignition-Controlled Door Locks; Secure Lock - Autostart AS-1414 Installation Manual

Always make all your connections before plugging in the module. Keep in mind to plug the
fuses as the last step before the initial powering of the module. Be sure to test all functions
properly before closing up the installation.
Make sure the warning label is applied on a visible place under the hood.

Supplementary Information

The following features can be programmed according to the user's needs and the
requirements of the installation.
Fifth Relay Output (2nd Ignition or 2nd Accessories or 2nd Crank
Output)
Note: Only one set of pins can be used at a time.
Caution: The relay output rating on this unit is 25 A at most. Defective OEM solenoid
switches can sometimes draw up to 50 or 60 A, causing the 30 A fuse to blow. Always
check your circuit with a proper measuring device.

Ignition-controlled Door Locks

( – by default.) This feature will automatically lock all doors as soon as the key is turned
OFF
to the
IGNITION ON (RUN)
turned to the
OFF

Secure Lock

( by default.) This feature allows the module to control certain OEM factory alarm
OFF
systems that use the factory lock wire to arm the alarm and the unlock wire to disarm it. If
secure lock is disabled (Option 1), the module will still disarm before remote-starting the
vehicle. If secure lock is enabled (Option 2), upon receiving a remote start signal the module
will the doors (disarming the factory alarm); 1/2 sec. after remote start it will re-lock
UNLOCK
the doors. 4 seconds after shutdown, secure lock will re-lock all doors once more (arming
the system again). NOTE: most OEM systems will not rearm the alarm while the engine is
running, but will lock the doors.

Passive or Active Arming Starter Kill

(Passive with a 1-min. timeout – by default.) The starter kill can be programmed to be
active (will not arm automatically) or passive (will arm automatically). In passive mode, you
can program it to arm automatically after 1 or 3 min.
AS-1414/ AS-1424
Installation Guide
position and the brake pedal is pressed. When the ignition key is
position, the doors will automatically unlock.
The module comes equipped with a high-
current programmable 5
used to power a 2
nd
crank wire.
The unit uses three sets of pins. Each set of
pins has a function. To activate one of the
three possible 2 outputs, place the jumper
nd
(supplied) on one of the three sets of pins
and connect the green 14 AWG wire either to
the 2 nd ignition wire, to the accessories wire
or to the crank wire of the vehicle.
relay which can be
th
ignition, accessory, or
P. 13