Install the second hot-plug power supply.
2.
Connect the power cord to the redundant power supply.
3.
Use the power cord management clip to secure the cord and form a service loop.
4.
Connect the power cord to the AC power source.
5.
Be sure that the power supply LED is green
6.
IMPORTANT:
powered by separate AC power sources.
Hot-plug SAS hard drive options
When adding hard drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one hard drive is used, install it in the bay with the lowest device number.
•
Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
("Rear panel
For maximum server availability, be sure that the two power supplies are
LEDs" on page 12).
Hardware options installation 53