Connect the power cable.
10.
Route and connect the SAS cables.
11.
Install the fan cage.
12.
Install the air baffle.
13.
Install the access panel.
14.
Do one of the following:
15.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
Install the hard drives and hard drive blanks.
16.
Power up the server (on page 22).
17.
Hardware options installation 62