Hp Sas Expander Card Option - HP DL370 - ProLiant - G6 Performance User Manual

IMPORTANT:
documentation that ships with the option.
To install the component:
Power down the server (on page 22).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 24).
o
Remove the access panel (on page 25).
3.
Remove the air baffle (on page 26).
4.
Install the storage controller.
5.
Connect the hot-plug SAS/SATA cable to the controller.
6.
For connector locations, see the documentation that ships with the controller.
Install the air baffle.
7.
Install the access panel.
8.
Do one of the following:
9.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Power up the server (on page 22).
10.

HP SAS Expander Card option

The HP SAS Expander Card is an optional controller that provides up to 24 connectors for internal SAS
hard drives.
IMPORTANT:
To install the component:
Power down the server (on page 22).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 24).
o
Remove the access panel (on page 25).
3.
Remove the air baffle (on page 26).
4.
Remove the fan cage (on page 26).
5.
Install the plastic bracket on the expander card (optional).
6.
The plastic bracket ships with the expander card. For more information, see the documentation that
ships with the option.
Install the expander card.
7.
Route and connect the cables.
8.
For additional installation and configuration information, refer to the
The HP SAS Expander Card is not supported in expansion slot 1.
("Open or remove the tower
("Open or remove the tower
Hardware options installation 79
bezel" on page 22).
bezel" on page 22).