If you are installing FBDIMMs in an online spare or mirrored configuration, use RBSU
5.
Based Setup
Hot-plug SAS hard drive options
When adding hard drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one hard drive is used, install it in the bay with the lowest device number.
•
Hard drives must be SFF types.
•
Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Installing a hot-plug SAS hard drive
Remove the hard drive blank.
1.
Utility" on page 66) to configure this feature.
("HP ROM-
Hardware options installation 44