Graphics Adapter Option; Tower-To-Rack Conversion Kit Option - HP DL370 - ProLiant - G6 Performance User Manual

For more information, see the documentation that ships with the expander card.
Install the fan cage.
9.
Install the air baffle.
10.
Install the access panel.
11.
Do one of the following:
12.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Power up the server (on page 22).
13.

Graphics adapter option

The server supports up to three high-power graphics adapters.
Install graphics adapters in the x16 PCIe expansion slots. For more information, see "System board
components (on page 13)."
Before installing a high-power graphics adapter in the server, be sure that the power supplies support the
installation of the adapter. Due the high power requirements for the adapter, a 750W or higher power
supply may be required. For more information, see the HP Enterprise Configurator website
(http://h30099.www3.hp.com/configurator/).
To install the component:
Power down the server (on page 22).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 24).
o
Remove the access panel (on page 25).
3.
Remove the air baffle (on page 26).
4.
Remove the fan cage (on page 26).
5.
Install the graphics adapter in a x16 PCIe expansion slot.
6.
Connect the power cables.
7.
For more information, see the documentation that ships with the graphics adapter power cable kit.
Install the fan cage.
8.
Install the air baffle.
9.
Install the access panel.
10.
Do one of the following:
11.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Power up the server (on page 22).
12.

Tower-to-rack conversion kit option

The tower-to-rack conversion kit includes all equipment required to convert the tower model server into a
rack model server and to install the server into most square- or round-hole racks.
("Open or remove the tower
Hardware options installation 80
bezel" on page 22).