Hardware Options Installation; Introduction; Processor Option - HP DL370 - ProLiant - G6 Performance User Manual

Hardware options installation

Introduction

If more than one option is being installed, read the installation instructions for all the hardware options
and identify similar steps to streamline the installation process.
WARNING:
internal system components to cool before touching them.
CAUTION:
beginning any installation procedure. Improper grounding can cause electrostatic discharge.

Processor option

The server supports single- and dual-processor operation. With two processors installed, the server
supports boot functions through the processor installed in processor socket 1. However, if processor 1
fails, the system attempts to boot from processor 2 and provides a processor failure message.
The server uses embedded PPMs to provide power to each processor.
CAUTION:
should attempt to replace or install the processor in this server.
CAUTION:
• Handle the processor only by the edges.
Do not touch the bottom of the processor, especially the contact area.
•
IMPORTANT:
server halts during POST.
To install the component:
Power down the server (on page 22).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 24).
o
Remove the access panel (on page 25).
3.
Remove the air baffle (on page 26).
4.
Open the processor retaining latch and the processor socket retaining bracket.
5.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the server before
To avoid damage to the processor and system board, only authorized personnel
To avoid damage to the processor:
Processor socket 1 must always be populated. If processor socket 1 is empty, the
("Open or remove the tower
Hardware options installation 39
bezel" on page 22).