•
Hardware options
•
Operating system or application software
•
PDU
Installing hardware options
Install any hardware options before initializing the server. For options installation information, refer to the
option documentation. For server-specific information, refer to "Hardware options installation (on page
39)."
Setting up a tower server
Follow the steps in this section to set up a tower model server. If you are going to install the server into a
rack, refer to the rack installation section
Place the server on a flat, stable surface.
1.
Install the the tower feet.
2.
Connect peripheral devices to the server.
3.
WARNING:
telephone or telecommunications connectors into RJ-45 connectors.
Connect the power cord to the rear of the server.
4.
Open the power cord retaining clip, and thread the power cord through the retaining clip.
5.
("Installing the server into the
("Rear panel
To reduce the risk of electric shock, fire, or damage to the equipment, do not plug
rack" on page 36).
components" on page 11)
Setup 35