Remove the hard drive blank.
1.
Install the hard drive.
2.
Determine the status of the hard drive from the hot-plug hard drive LEDs
3.
LEDs" on page 17).
Resume normal server operations.
4.
Hot-plug SAS hard drive options
When adding hard drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one hard drive is used, install it in the bay with the lowest device number
numbers" on page 16).
•
Hard drives must be SFF types.
•
Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
("SATA or SAS hard drive
("SAS-SATA device
Hardware options installation 45