Scanner Report; Scanner Address; Base Or Access Point Address - Honeywell 1900GHD-2 User Manual

The number of beeps and LED flashes emitted by the base for an error
condition can be programmed from 1 - 9. For example, if you program this
option to have five error beeps, there will be five error beeps and five LED
flashes in response to an error. To change the number of error beeps, scan
the bar code below and then scan a digit (1-9) bar code and the Save bar
code on the
Default = 1.

Scanner Report

Scan the bar code below to generate a report for the connected scanners. The
report indicates the port, work group, scanner name, and address. To assign a
name to your scanner, refer to

Scanner Address

Scan the bar code below to determine the address of the scanner you are
using.

Base or Access Point Address

Scan the bar code below to determine the address of the base or Access Point
you are using.
Programming Chart
Number of Base Error Beeps/LED Flashes
Menu Command
Scanner Report
Scanner Address
Base Address
inside the back cover of this manual.
Syntax, page 11-1.
3 - 11