Download  Print this page

Charging Information; Battery Recommendations - Honeywell 1900GHD-2 User Manual

Area-imaging scanner.
Hide thumbs

Advertisement

Charging Information

The battery is designed to charge while the scanner is positioned in the
cordless base unit. Refer to
Meaning, page 3-7, for an interpretation of the Charge Status indicators.
Refer to
Charge Only Mode
without linking it to the base.
Place the scanner in the base that is connected to an appropriate power
supply. Use only a Listed Limited Power Source (LPS) or Class 2 type
power supply with output rated 5 to 5.2Vdc, 1A.
Note: If you are powering the base through the interface cable (for
example, a USB cable) and not using an external power supply
plugged into the aux port, the current available for charging is
reduced and charge times are increased.

Battery Recommendations

• The battery is a lithium ion cell and can be used without a full charge, and
can also be charged without fully discharging, without impacting the
battery life. There is no need to perform any charge/discharge
conditioning on this type of battery.
• Keep the base connected to power when the host is not in use.
• Replace a defective battery immediately since it could damage the
scanner.
• Although your battery can be recharged many times, it will eventually be
depleted. Replace it after the battery is unable to hold an adequate
charge.
• If you are not sure if the battery or charger is working properly, send it to
Honeywell International Inc. or an authorized service center for
inspection. Refer to
information.
Caution:
Use only Honeywell Li-ion battery packs, part number
100000495, rated 3.7 Vdc, 7.4Whr, in this device. Use of any
non-Honeywell battery may result in damage not covered by
the warranty.
Safety Precautions for Lithium Batteries
Do not place batteries in fire or heat the batteries.
Do not store batteries near fire or other high temperature locations.
Do not store or carry batteries together with metal objects.
Do not expose batteries to water or allow the batteries to get wet.
Do not connect (short) the positive and negative terminals, of the
batteries, to each other with any metal object.
Do not pierce, strike or step on batteries or subject batteries to strong
impacts or shocks.
Do not disassemble or modify batteries.
Base/Access Point LED Sequences and
(page 3-12) if you need to charge a scanner
Customer Support on page 14-1
for additional
3 - 5

Advertisement

   Related Manuals for Honeywell 1900GHD-2

This manual also for:

Xwnon 1900Xwnon 1902

Comments to this Manuals

Symbols: 0
Latest comments: