Download  Print this page

Batch Mode Quantity - Honeywell 1900GHD-2 User Manual

Area-imaging scanner.
Hide thumbs


RAM Storage: The scanner will not power down while it contains data that
has not been transmitted to the base or Access Point, even if it reaches a
power down timeout. However, if the scanner runs out of battery power, it
will power down and the data will be lost.
Default = Flash Storage.
* Flash Storage

Batch Mode Quantity

When in Batch Mode, you may wish to transmit the number of multiple bar
codes scanned, rather than a single bar code multiple times. For example,
if you scan three bar codes called XYZ with Batch Mode Quantity Off,
when you transmit your data it will appear as XYZ three times. Using
Batch Mode Quantity On and the Quantity Codes
output your data as "XYZ, 00003" instead.
Note: If you wish to format your output, for example, place a CR or tab
between the bar code data and the quantity, refer to
Default = Batch Mode Quantity Off.
* Batch Mode Quantity Off
Entering Quantities
Quantity Codes
scanned, up to 9999 (default = 1). Quantity digits are shifted from right to
left, so if a 5th digit is scanned, the 1st digit scanned is discarded and the
2nd, 3rd and 4th digits are moved to the left to accommodate the new digit.
For example, if the Quantity 5 bar code is scanned after the quantity has
been set to 1234, then the 1 is dropped, the quantity will be 2345.
3 - 20
beginning on page 6-1.
3-22) allow you to enter a quantity for the last item
RAM Storage
3-22), you could
Batch Mode Quantity On


   Related Manuals for Honeywell 1900GHD-2

This manual also for:

Xwnon 1900Xwnon 1902

Comments to this Manuals

Symbols: 0
Latest comments: