If you want to be able to scan bar codes while the scanner is in the base cradle,
scan the Scanning in Cradle On bar code below. If you want to only allow
scanning when the scanner is out of the base cradle, scan Scanning in Cradle
Off. If you want the scanner to shut down when in the base cradle, scan Shut
Down Scanner in Cradle. Default = Scanning in Cradle On .
Scanning in Cradle Off
Shut Down Scanner in Cradle
Paging
Paging Mode
By default, the paging button on the base or Access Point pages the scan-
ners associated with that base or Access Point. If you want the paging but-
ton on your base or Access Point to be disabled, scan the Paging Mode
Off bar code, below. When Paging Mode is off, the base or Access Point
will no longer page scanners when the button is pressed. The red LED on
the base or blue LED on the Access Point will remain lit to indicate that
Paging Mode is off. (This light will go out when the button is pressed, then
back on when it's released.) Default = Paging Mode On.
* Paging Mode On
* Scanning in Cradle On
Paging Mode Off
3 - 9