Download  Print this page

Inspecting Cords And Connectors; Replacing Cables In Corded Scanners - Honeywell 1900GHD-2 User Manual

Area-imaging scanner.
Hide thumbs

Advertisement

Important! The following cleaning solutions have been tested to assure
safe cleaning of your scanner's disinfectant-ready housing. They are the
only solutions approved for use with these scanners. Damage caused by
the use of cleaners other than those listed below may not be covered by
the warranty.
• Sani-Cloth
• Sani-Cloth
• Super Sani-Cloth
• Isopropyl Alcohol wipes (70%)
• CaviWipes
®
• Virex
256
®
• 409
Glass and Surface Cleaner
®
• Windex
®
• Clorox
Bleach – 10%
• Gentle dish soap and water

Inspecting Cords and Connectors

Inspect the interface cable and connector for wear or other signs of dam-
age. A badly worn cable or damaged connector may interfere with scanner
operation. Contact your distributor for information about cable replace-
ment. Cable replacement instructions are on

Replacing Cables in Corded Scanners

The standard interface cable is attached to the scanner with an 10-pin modular
connector. When properly seated, the connector is held in the scanner's handle
by a flexible retention tab. The interface cable is designed to be field replace-
able.
• Order replacement cables from Honeywell or from an authorized distributor.
• When ordering a replacement cable, specify the cable part number of the
original interface cable.
13 - 2
®
HB wipes
®
Plus wipes
®
wipes
Blue
page
13-2.

Advertisement

   Related Manuals for Honeywell 1900GHD-2

This manual also for:

Xwnon 1900Xwnon 1902

Comments to this Manuals

Symbols: 0
Latest comments: