Download  Print this page

Scanner To Bioptic Communication; Scanner-bioptic Packet Mode - Honeywell 1900GHD-2 User Manual

Area-imaging scanner.
Hide thumbs


the scanner waits for ACK/NAK again. Turn on the ACK/NAK protocol by
scanning the ACK/NAK On bar code below. To turn off the protocol, scan
ACK/NAK Off. Default = ACK/NAK Off .

Scanner to Bioptic Communication

The following settings are used to set up communication between Honeywell
scanners and bioptic scanners.
Note: The scanner's baud rate must be set to 38400 and the RS232 timeout
must be set to 3000 in order to communicate with a bioptic scanner. See
RS232 Baud Rate
further information.

Scanner-Bioptic Packet Mode

Packet Mode On must be scanned to set the scanner's format so it is com-
patible with a bioptic scanner. Default = Packet Mode Off.
* Packet Mode Off
2 - 24
on page 2-20, and
RS232 Timeout
on page 2-23 for
Packet Mode On


   Related Manuals for Honeywell 1900GHD-2

This manual also for:

Xwnon 1900Xwnon 1902

Comments to this Manuals

Symbols: 0
Latest comments: