Changing The Scanner's Bluetooth Pin Code; Minimizing Bluetooth/Ism Band Network Activity; Auto Reconnect Mode - Honeywell 1900GHD-2 User Manual

Changing the Scanner's Bluetooth PIN Code

Some devices require a PIN code as part of the Bluetooth security features.
Your scanner's default PIN is 1234, which you may need to enter the first
time you connect to your PDA or PC. The PIN code must be between 1
and 16 characters. To change the PIN, scan the bar code below and then
scan the appropriate numeric bar codes from the
inside the back cover of this manual. Scan Save to save your selection.

Minimizing Bluetooth/ISM Band Network Activity

The settings described below can help you customize the relinking behavior of
the cordless area-imaging system to obtain the best compromise between con-
venience and low interference.
Note: ISM band refers to the 2.4 to 2.48 GHz frequency band used by wireless
networks, cordless phones, and Bluetooth.

Auto Reconnect Mode

Auto Reconnect controls whether or not the scanner automatically begins
the relink process when a loss of connection is detected. When the Auto
Reconnect On bar code is scanned, the scanner begins the relink process
immediately, without user intervention. Default = Auto Reconnect On.
* Auto Reconnect On
Note: If you are connecting to a Bluetooth Interface Module, set Auto
Reconnect to Off.
Bluetooth PIN
Programming Chart
Auto Reconnect Off
3 - 33