Attaching The Tripod Base (Provided) - JVC GY-DV5000 Instructions Manual

3. BASIC SYSTEM CONNECTIONS AND ADJUSTMENTS

3-6 Attaching the Tripod Base (Provided)

1.
Tripod mounting holes
Front mount clip
2.
Safety lever
4.
Front
base
mount
FILTER
1 3200K
2 5600K 1 8 / ND
.3 5600K
.4 5600K / ND 1 64
STATUS
SHUTTER
MENU
AUTO IRIS FULL AUTO
BACK L
NORMAL
SPOT L
POWER
ON
32
3.
Pin
2.
Lock lever
3.
Rear base
mount
4.
OPEN
EDITSEARCH
MONITOR
LCD BRIGHT DISPLAY
AUDIO
PULL
LEVEL
OPEN
FRONT
BLACK LOLUX REAR
CH-1 CH-2
CH-1 CH-2
MODE AUDIO INPUT
STRETCH AUDIO SELECT
VTR
NORMAL CH-1 CH-2
COMPRESS AUTO
CAM
MANUAL
VTR
OFF
Use the provided KA-550U tripod base to place the camera on
a tripod.
1.
Attach the tripod base on the tripod by using the hole that
balances the unit most optimally.
2.
While pushing the safety lever, pull the lock lever toward
the front until the front mount clip clicks into place.
3.
Place the unit on the tripod base by aligning the rear base
mount of the unit with the pin on the tripod base.
4.
Push the unit from the upward direction and slide it toward
the front so that the front base mount of the unit is locked
by the front mount clip of the tripod base as it clicks into
place.
CAUTION:
● The front base mount may be locked while the pin of the
tripod base is not inserted into the hole on the rear base
mount of the unit. Therefore, after mounting, make sure
that these parts are engaged properly.
● When moving the unit mounted on a tripod, any impact
or vibration should be avoided as this may cause the
unit to become detached and to drop from the tripod.
Be sure to remove the unit from the tripod before
transporting it.