Table of Contents
Advertisement
Register Description
2.10.5
MC_CHANNEL_0_DDR3CMD
MC_CHANNEL_1_DDR3CMD
MC_CHANNEL_2_DDR3CMD
DDR3 Configuration Command. This register is used to issue commands to the DIMMs
such as MRS commands. The register is used by setting one of the *_VALID bits along
with the appropriate address and destination RANK. The command is then issued
directly to the DIMM. Care must be taken in using this register as there is no
enforcement of timing parameters related to the action taken by a DDR3CMD write.
This register has no effect after MC_CONTROL.INIT_DONE is set.
Device:
Function: 0
Offset:
Access as a Dword
Bit
28
27
26
25
24
23
22:20
19:16
15:0
Datasheet
4, 5, 6
60h
Reset
Type
Value
PRECHARGE_VALID.
RW
0
Indicates current command is for a precharge command.
ACTIVATE_VALID.
RW
0
Indicates current command is for an activate command.
REG_VALID.
Indicates current command is for a registered DIMM config write Bit is cleared
RW
0
by hardware on issuance. This bit applies only to processors supporting
registered DIMMs.
WR_VALID.
RW
0
Indicates current command is for a write CAS. Bit is cleared by hardware on
issuance.
RD_VALID.
RW
0
Indicates current command is for a read CAS. Bit is cleared by hardware on
issuance.
MRS_VALID.
RW
0
Indicates current command is an MRS command. Bit is cleared by hardware on
issuance.
RANK.
RW
0
Destination rank for command.
MRS_BA.
RW
0
Address bits driven to DDR_BA[2:0] pins for the DRAM command being issued
due to a valid bit being set in this register.
MRS_ADDR.
RW
0
Address bits driven to DDR_MA pins for the DRAM command being issued due
to a valid bit being set in this register.
Description
63
Advertisement
Table of Contents
