Configuring An Existing Storage System - Dell EMC2 AX100 Series Installing Manual

Configuring an Existing Storage System

Configuring an Existing Storage System
Before You Start
Start Navisphere Express If It Is Not Already Running
AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a Solaris Server
62
Read this section if you are configuring an existing AX100SC or
AX100 storage system. An existing storage system is one that was
already connected to a server when you started the installation
procedure.
You need to complete the configuration planning worksheets from
Planning Your AX100-Series Fibre Channel Storage-System Configuration
in the "Plan" section on the AX100 support website or the
AX100-Series Documentation CD.
1. Open an Internet browser, such as Internet Explorer or Netscape,
on the server or on any host on the same LAN as the storage
system.
2. Enter the IP address of an SP in the storage system.
This address is the one you assigned when you initialized the storage
system.
If Navisphere Express does not open, make sure that the storage
system is not rebooting. When the reboot is complete, the
SP Boot/Fault light on the back of each SP is off and not blinking.
If the storage system is not rebooting and Navisphere Express still
does not open, go to the "Troubleshoot" section on the AX100
support website or the AX100-Series Documentation CD.
3. Log in to Navisphere Express by entering the username and
password that you specified when you initialized the storage
system.