Wired Network - Xerox DocuPrint C1190 FS User Manual

Wired Network

Specifies printer settings affecting jobs sent to the printer through a network port.
The settings in the Network Settings menu cannot be set when entering this menu during printing.
You need to restart the printer to activate the new settings. After making the settings, turn off the printer,
and then turn it back on again.
Ethernet: Specifies the communication speed and the modes of Ethernet.
■
Auto (default): Automatically detects 10Base Half, 10Base Full, 100Base Half, and 100Base Full.
■
10 BASE-T Half: Uses 10base-T half-duplex.
■
10 BASE-T Full: Uses 10base-T full-duplex.
■
100 BASE-TX Half: Uses 100base-TX half-duplex.
■
100 BASE-TX Full: Uses 100base-TX full-duplex.
■
TCP/IP: Specifies the TCP/IP settings for the network.
■
Get IP Address: Specifies whether to automatically or manually retrieve the IP address.
■
DHCP/AutoIP (default): Automatically sets the IP address.
■
BOOTP: Uses BOOTP to set the IP address automatically.
■
RARP: Uses RARP to set the IP address automatically.
■
DHCP: Uses DHCP to set the IP address automatically.
■
Panel: You can set the IP address manually by entering it on the printer console.
■
IP Address, Subnet Mask, and Gateway Address: These items are used to check the addresses
■
that have been obtained automatically or to specify addresses manually. Enter the address in the
format of xxx.xxx.xxx.xxx. You can specify values in the range of 0 to 255 for xxx.
To set addresses manually, set Get IP Address to Panel.
IP addresses are managed in the entire network. An incorrect IP address may affect the whole
network. For the addresses you need to set manually, contact your network administrator.
Protocol
■
Set Enable when using the protocol. When Disable is selected, the protocol cannot be activated.
LPD (default: Enable)
■
Port 9100 (default: Enable)
■
FTP (default: Enable)
■
SNMP (default: Enable)
■
StatusMessenger (default: Enable)
■
InternetServices (default: Enable)
■
Bonjour [mDNS] (default: Enable)
■
IP Filter: Specifies blocking the reception of data from certain IP addresses. You can block up to five
■
IP addresses. The change becomes effective after the printer is turned off and then on again.
Note:
This feature is only available when using LPD or Port9100.
Initialize NVM: Initializes network data stored in NVM. After executing this function and rebooting
■
the printer, all network settings are reset to their default values.
Fax Settings
The Fax Settings menu contains the following items:
Interval Timer: Specifies the interval time between resent attempts.
■
9-9
Description of Menu Items