Table of Contents
Advertisement
Manually Setting the Printer's IP Address
Note:
Verify that your computer has a properly configured IP address for your network. Contact your
network administrator for more information.
If you are on a network without a DHCP server, or in an environment where the network administrator
assigns printer IP addresses, you can use this method to manually set the IP address. Manually setting the
IP address overrides DHCP and AutoIP. Alternatively, if you are in a small office with a single PC and use
a dialup modem connection, you can manually set the IP address.
Information Required for Manual IP Addressing
Information
Internet Protocol (IP) address of the printer
Network Mask
Default Router/Gateway address
Using the Printer Console
To manually set the IP address:
1.
On the printer console, press the System button.
2.
Select the Admin Menu, and then press the OK button.
3.
Select the Wired Network menu, and then press the OK button.
4.
Select the TCP/IP menu, and then press the OK button.
5.
Select the IPv4 menu, and then press the OK button.
6.
Select Get IP Address, and then press the OK button.
7.
Select Panel, and then press the OK button.
8.
Select IP Address under the IPv4 menu and use the arrows to configure the IP values, and then press
the OK button.
Configuring the Network Address
Comments
xxx.xxx.xxx.xxx
Format is
decimal number from 0–255.
If you are unsure, leave this blank; the printer chooses
an appropriate mask.
Router address is required to communicate with the
host device from anywhere other than the local network
segment.
4-7
xxx
, where
represents a
Advertisement
Table of Contents
