Sensor Test (Finisher); Base Sensor Test; Device Tests; Quick Disk Test - Toshiba e-STUDIO500P Service Manual

BASE SENSOR TEST

This test is used to determine if the sensors located inside the printer are working correctly.
To run the Base Sensor Test:
1.
Select BASE SENSOR TEST from the DIAGNOSTICS menu.
The following sensors are listed:
•
Exit—Exit sensor
•
Front Door—Front door sensor
•
Input—Input sensor
•
NarrowMedia—Output (exit) sensor
•
Toner Level—Toner level sensor (remove the cartridge and replace to actuate the sensor)
Manually actuate the sensors to verify that each sensor switches from Open to Closed.
2.
3.
Press Back (

DEVICE TESTS

Quick Disk Test

This test performs a non-destructive read/write on one block per track on the disk. The test reads one block on
each track, saves the data, and proceeds to write and read four test patterns to the bytes in the block. If the block
is good, the saved data is written back to the disk.
To run the Quick Disk Test:
1.
Select Quick Disk Test from DEVICE TESTS.
The power indicator blinks while the test is in progress, and quick Disk Test Testing... displays.
Quick Disk Test/Test Passed message displays if the test passes, and the power indicator
•
turns on solid.
Quick Disk Test/Test Failed message displays if the test failed, and the power indicator turns
•
on solid.
2.
Press Back (
3-18
Service Manual
) or Stop ( ) to exit the test.
) or Stop ( ) to return to the Device Tests menu.