Removing The Paper-Out Sensor - Toshiba 1NR Hardware Service Manual

Removing and replacing FRUs
1. Ensure that the paper door is in the closed position, with its top cover removed.
2. Slide the main cover down over the unit until the main cover release tab snaps

Removing the paper-out sensor

Attention:
is recommended: You should touch the metal on the printer frame with the back of
your hand before allowing the printhead to make contact with the printer. Also, see
"Handling static-sensitive devices" on page 51.
Follow these steps to remove the paper-out sensor:
1. Turn off the printer and disconnect the power and signal cables from the rear of
2. Press the paper door release button to open the paper door (see Figure 15 on
3. Pull gently on the top of the paper-out sensor to pivot it open.
Figure 18. Paper-out sensor
4. Disconnect the cable that connects the paper-out sensor to the logic card.
5. Pull the paper-out sensor tab until the pivot point is removed from its hole; then,
Attention:
damage from static electricity. For details about handling these devices, see
"Handling static-sensitive devices" on page 51.
56
SureMark Hardware Service
into place.
Note: You might have to rock the main cover back and forth slightly to get it
onto the unit.
Printer should be powered off. The following ESD handling procedure
the printer.
page 53 for the location of the paper door release button).
rotate the paper-out sensor up and out of the printer.
When you handle static-sensitive devices, take precautions to avoid
A B