Configuring The Paper Low Sensor For Wall Mounting; Installing An Optional Interface Adapter Card - Toshiba 1TN Quick Installation Manual

6. When the printer is properly latched into place, verify that the printer does not move up and
down. Also confirm that the printer is securely attached to the wall.
To remove the printer from the wall mounting bracket:
1.
Press and hold the release latch
2. While pressing the release latch, lift the printer up and off the wall mounting bracket.

Configuring the paper low sensor for wall mounting

When mounting the printer to the wall, you will need to configure the printer before using.
Note: The printer only has to be configured when it is first mounted to the wall.
To configure the paper low sensor, flick the small gray paper low sensor tab
flat instrument (such as a screwdriver) to rotate it from the "H" position to the "WALL" position
(see Figure 5).
Figure 5. Rotation of paper low sensor

Installing an optional interface adapter card

There is an option slot on the back of the Toshiba TCx Single Station printer that can extend the
functionality of the base printer. The optional interface adapter card can be either an Ethernet,
WiFi, or RS-232 interface adapter card.
14
TCx Single Station Printer Installation and Service Guide
(see Figure 4 ).
B
using a sharp,
A
A