Signature Button Contact Assembly Removal - Toshiba e-STUDIO500P Service Manual

Signature button contact assembly removal

1.
Remove the print cartridge.
2.
Remove the left side door. See
3.
Remove the right cover. See
4.
Remove outer system board shield. See
5.
Disconnect signature button cable from connector J14 on the system board.
6.
On models 200/210/400/410, remove the two screws (A) securing the blower duct.
7.
Remove the signature button contact assembly mounting screw (B).
8.
Remove the assembly signature button contact assembly.
Note: Be sure to route the cable in the same location, as shown (C), when replacing the assembly.
"Left door removal" on page
"Right cover removal" on page
"Outer shield removal" on page
4-6.
4-8.
4-67.
Repair information
4-75