Toshiba e-STUDIO500P Service Manual page 244

7.
Pull the LVPS assembly far enough out from the right side of the printer to disconnect the fuser to LVPS
AC cable from the LVPS (E).
Note: The LVPS assembly may be difficult to remove from the printer. Do not use excessive force in the
removal.
8.
Remove the fuser to LVPS AC cable.
Installation
1.
Plug in the fuser to LVPS AC cable (A) into the LVPS.
2.
Route the cable through the channel (B) on the right side frame above the LVPS, under the clip (C) over the
LVPS, and through the notch in the frame (D).
4-39
Repair information