Paper Alignment Assembly Adjustment - Toshiba e-STUDIO500P Service Manual

Paper alignment assembly adjustment

Do the alignment assembly adjustment whenever you replace the alignment assembly. Always print a copy of the
Quick Test Page before making any adjustments to the alignment assembly reference adjustment screw. When
replacing the alignment assembly, it is necessary to back the reference adjustment screw out far enough to
remove the old assembly and install the new one.
•
If you are replacing the alignment assembly, go to step A.
•
If you are only adjusting the reference adjustment screw, go to step B.
Step A
Print a copy of the Quick Test Page and check the margin adjustments printed on the test page. These settings
should be within the range specified in
Do the reference adjustment if you are sure the margins are set correctly.
1.
Loosen the locknut on the inside rear of the alignment assembly.
2.
Remove the two screws holding the alignment assembly to the left side frame.
3.
Back the reference adjustment screw out far enough to allow the alignment assembly to be removed from
the printer. It is not necessary to completely remove the screw.
4.
Install the new alignment assembly. Turn the reference screw clockwise with a 7 mm nut driver until it
touches the back of the reference plate, and tighten the nut with a 5.5 mm wrench.
The reference adjustment screw can be adjusted without loosening the nut. Turn the screw clockwise a few turns
and print a copy of the Quick Test Page as you check the diamonds on the left margin. Continue adjusting the
screw as you check the results of each adjustment on a new test page until you obtain the results you want.
Step B
Print a copy of the Quick Test Page, and check the margin adjustments printed on the test page. These settings
should be within the range specified in
without loosening the locknut. Turn the screw a few turns, and print a copy of the Quick Test Page as you check
the diamonds on the left margin. Continue adjusting the screw as you check the results of each adjustment on a
new test page until you obtain the results you want.
"REGISTRATION" on page
"REGISTRATION" on page
3-4.
3-4. The reference screw can be adjusted
Repair information
4-3